3 Series E46 318td (M47TU) COMP
Remove engine underguard.
Drain and dispose of coolant.
Refer to general instructions for work on cooling system.
Installation:
Replace seal.
Tightening torque, 11 11 5AZ .
Cooling system must be topped up, vented and checked for leaks.
Release clamp from intake pipe on exhaust gas recirculation valve
(EGR).
Detach clamp from EGR cooler/pipe.
Installation:
Tightening torque 11 71 1AZ
Release cable.
Disconnect plug from electropneumatic pressure transducer
(EPPT) for exhaust gas recirculation valve (EGR).
Release screws (arrow).
Remove EGR valve.
Detach coolant hose on engine side from quick-release coupling
and place to one side.
Note:
Illustration of removed line
Disconnect all quick-release couplings on coolant connecting line.
Release the two retaining screws.
Remove coolant connecting line.
RA Removing and installing/sealing or replacing complete main flow oil filter (M47T
BMW AG - TIS
11.02.2013 16:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
