3 Series E46 318ti (N42) COMP
Install spark plug domes (1) on cylinder (1 and 4).
Important!
When fitting cylinder head cover:
Align spark plug domes (1) to cylinder head cover.
Cylinder head, front:
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Cylinder head, rear (exhaust side):
Note:
Illustration with engine removed.
Remove all sealing remnants from sealing surfaces of cylinder
head.
As illustrated, apply a sealing bead with Drei Bond 1209 (refer
to BMW Parts Service).
Cylinder head, rear (inlet side):
Note:
Illustration with engine removed.
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
RA Removing and installing/sealing cylinder head cover (N42/N46)
BMW AG - TIS
12.02.2013 01:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
