3 Series E46 318ti (N42) COMP
Note:
The required parts are available from the BMW Parts Service
(EPC).
Remove screw caps (1) from injector (2).
Screw on needle and insert plunger.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
Push support sleeve (1) with radial seal (2) onto special tool
11 9 232 .
Important!
Support sleeve (1) remains on special tool
11 9 232 , until
radial seal is drawn in.
Align groove (3) centrally to housing partition (4).
Coat both grooves (3) on radial seal (2) with Loctite primer,
manufacturer's number 171000, and expose to air for approx.
one minute.
Draw in radial seal with special tool 11 9 231 in conjunction
with special tool 11 9 233 until flush.
Before filling with sealing compound:
Insert brush with Loctite primer, manufacturer's number 128357,
as far as possible into grooves (1) on radial seal and coat
housing partition on engine block.
RA Replacing front crankshaft radial seal (N40/N 42/N45/N46)
BMW AG - TIS
12.02.2013 01:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
