3 Series E46 318ti (N42) COMP
Insert exhaust camshaft (1) so that curvature on twin surface
points upwards.
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
Bearing caps of exhaust camshaft are marked A1 to A4 from inlet
side.
Lubricate exhaust camshaft and bearing caps with engine oil.
Fit bearing caps of exhaust camshaft.
Insert all nuts and install without play.
Tighten down nuts on bearing caps in 1/2 turn increments from
inside outwards.
Tightening torque 11 31 1AZ
.
RA Removing and installing/replacing exhaust camshaft (N42/N46)
BMW AG - TIS
12.02.2013 01:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
