3 Series E46 318ti (N42) COMP
Remove heat shield (1).
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center mount (1). Detach
propeller shaft from transmission output flange and tie back to
side on vehicle underbody.
Grip output flange (1) with special tool 23 0 020.
Release hexagon nut.
Detach output flange (1).
Installation:
Install hexagon nut with screw retaining compound.
RA Installing output flange add-on kit (A5S 360R)
BMW AG - TIS
12.02.2013 04:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
