3 Series E46 320Cd (M47TU) CONVER
Installation:
M47TU1 / M47TU2 M57TU1 / M57TUTop:
Piston protrusion 0.72 to 0.83 mm
-
Install 1-hole cylinder head gasket.
Piston protrusion greater than 0.83 ... 0.93 mm
-
Install 2-hole cylinder head gasket.
Piston protrusion greater than 0.93 ... 1.04 mm
-
Install 3-hole cylinder head gasket.
Check dowel sleeves (1) for damage and correct installation
position.
Fit new cylinder head gasket with previously determined gasket
thickness (number of holes).
Fit cylinder head and tighten down using new screws (slightly
oiled) in sequence 1 ... 10.
Tightening torque 11 12 7AZ .
Use special tool 00 9 120 as a torsion angle bracket.
RA Removing and installing cylinder head (M47TU / M47T2)
BMW AG - TIS
12.02.2013 03:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -