3 Series E46 320Cd (M47TU) CONVER
11 61 050
Removing and installing intake air manifold
(M47TU / M47T2)
Necessary preliminary tasks:
•
Disconnect battery terminal.
•
Disconnect lead from battery positive terminal.
•
Remove lower microfilter compartment.
•
Remove front and rear acoustic insulation panels.
•
Detach dipstick from intake manifold.
•
Disconnect plug connection at charge-air pressure sensor.
•
Detach vacuum line and plug connection from electric valve.
Unfasten release element (1) in direction of arrow.
Release pressure pipe (2) in direction of arrow.
Detach EGR tube from EGR valve.
If necessary, disconnect plug connection on electronic throttle
valve.
Unfasten screws (2).
Unscrew nuts (1).
Installation:
Nuts (1) may fall out slightly during removal and installation.
Nuts (1) with M7 thread.
Installation:
Clean sealing faces.
Replace sealing rings (1).
Check rubber mount (2), replace if necessary.
RA Removing and installing intake air manifold (M47TU / M47T2)
BMW AG - TIS
12.02.2013 03:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -