3 Series E46 320Cd (M47TU) CONVER
Detach plug and hose connections on manifold.
Note:
(Changeover valve for swirl flaps and with engines with manual
transmissions switchover valve for radiator shutter / plug
connection for boost pressure sensor.)
Detach grommet from line to pressure regulator.
Release oil dipstick guide tube on manifold.
Do not remove guide tube.
Note:
The nuts (1) fall out very easily during removal and
installation, use special tool 00 2 190 if necessary.
Unfasten screws (2) and nuts (1).
Remove intake air manifold.
(Illustrations show M47 engine)
Note:
The intake air manifold is vibrationally separated by rubber
mounts and seals from the cylinder head and cylinder head
cover.
Installation:
Clean sealing faces.
Replace sealing rings (1) in intake air manifold.
Check rubber mount (2), replace if necessary.
Installation:
Fit intake air manifold.
Note:
The nuts (1) fall out very easily during removal and
installation, use special tool 00 2 190 if necessary.
Nuts (1) with M7 thread.
Screws (2) with M6 thread.
Insert nuts (1) and tighten to initial torque of approx. 10 Nm.
Insert screws (2).
-
Tighten down nuts (1).
-
Tighten down screws (2).
RA Removing and installing intake air manifold (M47TU)
BMW AG - TIS
12.02.2013 03:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
