bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Replacing Battery Positive Lead (between Starter Motor And Alternator) (M54 _ M5|Page 789 > < 1 RA Replacing Battery Positive Lead (between Starter Motor And B- Terminal) (M54 _ M|Page 787
Page 1
background image

12 42 530

Replacing battery positive lead (between
starter motor and alternator) (M54 / M56)

Read fault memory. Switch off ignition.

Observe safety instructions for handling vehicle battery.

Remove front underbody protection.

Observe instructions for disconnecting and connecting battery.

Disconnect battery negative lead from battery and lay to one side.

Remove suction filter housing.

Release nut and disconnect battery positive lead (2) from
alternator.

Installation:

Tightening torque, 12 31 1AZ

.

E46 only:

Remove reinforcement plate on front axle support.

Caution!

The section "Removing and installing reinforcement plate on
front axle support" contains important installation instructions.

If fitted:

Remove vacuum reservoir for exhaust flap.

RA  Replacing battery positive lead (between starter motor and alternator) (M54 / M5

BMW AG - TIS

12.02.2013  13:30

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Replacing Battery Positive Lead (between Starter Motor And Alternator) (M54 _ M5|Page 789 > < 1 RA Replacing Battery Positive Lead (between Starter Motor And B- Terminal) (M54 _ M|Page 787