3 Series E46 320Ci (M54) COUPE
Correcting height:
Release nuts on hinges (1) and (2) and turn/move door.
Tighten nuts.
Tightening Torque,
refer to Technical Data 41 51 1AZ.
Note:
Gap must continue to run uniformly between door and sill. If
necessary, repeat previous work steps.
Check door protrusion, bottom,
refer to Gap measurements, doors/hood and rear lid 41 00 ...
If you need to correct, release nuts on hinge (2) and correct
deviations by number and/or thickness of shims on hinge (2).
Tighten nuts.
Tightening torque,
refer to Technical Data 41 51 1AZ.
Check door protrusion (2), rear,
refer to Gap measurements, doors/hood and rear lid 41 00 ...
Note:
Door height (1): flush
When the door is closed, the closing bar must not make
contact or slip in the lock.
If you need to correct, move closing bar inwards or outwards.
Tighten down screws on closing bar.
Tightening torque,
refer to Technical Data 41 51 2AZ.
Attach cover above closing bar on B-pillar.
RA Adjusting left or right front door
BMW AG - TIS
12.02.2013 20:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -