3 Series E46 320d (M47) SAL
Fit cylinder head and tighten down using new screws (slightly
oiled) in sequence 1 ... 10.
Tightening Torque,
refer to Technical Data 11 12 7AZ.
Use special tool 00 9 120 for torsion angle tightening.
Replace sealing ring on screw (1).
Install and tighten down screw (1) between timing case cover and
cylinder head.
Install and tighten down screws.
RA Removing and installing cylinder head (M47)
BMW AG - TIS
12.02.2013 12:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -