3 Series E46 320d (M47) SAL
12 41 020
Removing and installing or replacing starter
(M47)
Read fault memory. Switch off ignition.
Instructions for disconnecting and connecting battery.
Disconnect battery negative lead.
Remove engine underguard.
E46 only:
Release screw (1) and remove side sound insulation (2).
E46 and E39:
Disconnect positive leads (1) and both control leads (2 and 3)
from starter.
Installation:
Tightening torque,
refer to Technical Data 12 41 4AZ.
Note:
Illustration shows starter screw connection on removed
engine.
Release screw (1) on sound insulation.
Release screws (2) and swivel out starter past engine support.
Installation:
Tightening torque,
refer to Technical Data 12 41 1AZ.
RA Removing and installing or replacing starter (M47)
BMW AG - TIS
12.02.2013 13:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -