3 Series E46 320d (M47) SAL
Install special tool 13 5 200.
Secure special tool 00 2 510 (dial gauge) under preload.
Pull out special tool 11 2 300.
Rotate crankshaft 90
°
against direction of engine rotation. Set
scale of dial gauge to zero.
Lay special tool 11 2 300 (plug mandrel) parallel to speed
sensor (1) on reinforcing rib of engine and force it approx. 1...2 cm
into support in crankcase.
Note:
To provide more space to work in, remove injection lines for
cylinders 3 and 4,
refer to 13 53 200.
Rotate crankshaft in direction of engine rotation until special tool
11 2 300 (plug mandrel) audibly snaps into place.
Note:
Cast lug (1) on inlet camshaft points upwards at firing TDC,
cylinder 1.
Read dial gauge.
Evaluation of measurement:
The value read off may deviate from the value stamped on the
injection pump by max.
±
0.1 mm.
If deviations are greater than
±
0.1 mm, statically adjust
injection pump,
refer to 13 51 005.
RA Checking injection pump measured value (M47)
BMW AG - TIS
12.02.2013 13:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -