3 Series E46 320d (M47TU) SAL
Detach sealing strip (1).
Pull out profile seal (2).
Installation:
To prevent leaks, you must install profile seals correctly.
Release screws (1).
Remove cover from electronics box.
Installation:
Tightening torque, 12 90 4AZ .
Disconnect plug (1) on DDE control unit.
Pull profile seal of wiring harness out of electronics box.
Installation:
To prevent leaks, you must install profile seals correctly.
Remove wiring harness section for injectors.
Pull out lock.
Press out the two plugs belonging to the injector wiring harness.
RA Replacing wiring harness section for injectors (M47TU)
BMW AG - TIS
12.02.2013 14:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -