3 Series E46 320d (M47TU) SAL
Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Release union nuts on pressure lines (1 to 4) with special tool
13 5 020 .
Note:
Reset special tool in good time in order to avoid bending pressure
lines.
Installation:
If replacing:
Do not mix up pressure lines!
•
Even final digit of part no. = cylinders 2, 4
•
Uneven final digit of part no. = cylinders 1, 3
Installation:
Risk of injector breakage!
Observe tightening torque 13 53 8AZ
without fail.
1.
Hand-tighten all union nuts on pressure lines.
2.
Tighten down union nuts on injectors to specified torque.
3.
Check all components of common rail system for leaks.
RA Replacing all pressure lines (M47TU / M47T2)
BMW AG - TIS
12.02.2013 14:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -