3 Series E46 320d (M47TU) SAL
Warning!
Danger of pinching!
If the engine is inadequately positioned, it rests on the
stabilizer.
Unfasten screws.
Tightening torque 23 00 1AZ .
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
RA Removing and installing transmission (GS5-39DZ, M47TU / M57)
BMW AG - TIS
12.02.2013 15:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
