3 Series E46 320d (M47TU) SAL
32 31 070
Removing and installing / replacing lower
section of steering spindle
After installation:
•
Carry out steering angle sensor adjustment
•
Turn steering wheel in both directions to full lock
Note: The airbag warning lamp must not light up in the
process.
•
Check directional stability of car
Move steering wheel to straight-ahead position.
Lock steering lock -> remove ignition key.
Unscrew and remove splash guard.
Release clamping screw.
Detach flexible disk/double joint from power steering gear.
Installation:
If necessary, move power steering gear to straight-ahead position
- markings on cap (1) and housing (2) must match up.
Replace clamping screw.
Tightening torque 32 31 1AZ
.
Release clamping screw.
Remove lower section of steering spindle with flexible disk/double
joint.
Installation:
Lower section of steering spindle can only be attached in one
position to the steering column.
Replace clamping screw.
Tightening torque 32 31 1AZ
.
RA Removing and installing / replacing lower section of steering spindle
BMW AG - TIS
12.02.2013 17:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
