3 Series E46 320i (M52TU) SAL
Remove microfilter.
Open cable duct on lower section of microfilter housing (2) and
feed out cable(s).
Release screws (1) and remove lower section of microfilter
housing (2).
Remove engine underguard.
Remove transmission, refer to MG 23 / MG 24.
Remove A/C compressor drive belt.
Remove A/C compressor from bearing block and tie back to one
side.
Note:
Lines remain connected.
Drain and dispose of coolant.
Note:
The water drain plug is located on the exhaust side on cylinder 2
in the engine block.
Installation:
Replacing sealing ring on water drain plug.
Tightening torque 11 11 5AZ
.
Pull locks (1) and disconnect water hoses.
Installation:
Refer to general instructions for work on cooling system.
Remove radiator.
RA Removing and installing engine (M52TU / M54 / M56)
BMW AG - TIS
12.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -