3 Series E46 320i (M52TU) SAL
Remove cover from fuel injectors.
Remove both oxygen monitor sensors.
Remove intake air manifold.
Disconnect water hoses from water pipe and from heating valve.
Unfasten engine section of wiring harness and place to one side
with cable duct.
Unfasten reservoir for power steering unit and tie up to one side.
Note:
Lines remain connected.
Remove fan clutch with fan impeller from water pump.
Remove alternator drive belt.
Remove vane pump for power steering and tie back to one side.
Note:
Lines remain connected.
Suspend engine from special tool 11 0 000 .
RA Removing and installing engine (M52TU / M54 / M56)
BMW AG - TIS
12.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
