3 Series E46 320i (M52TU) SAL
Version 2
Insert special tool 11 8 200 in openings on vibration damper
and turn counterclockwise so that counter-supports snap into
place on vibration damper.
Release central screw (1).
Version 2
Feed out special tools 11 8 190 / 11 8 200 .
Remove central screw and washer.
Carefully detach vibration damper (1) by hand.
Version 2
Note:
If vibration damper cannot be detache by hand:
Insert special tool 11 8 200 in openings on vibration damper
and turn clockwise so that counter-supports snap into place on
vibration damper.
Version 2
Screw out spindle (1) on special tool 11 8 210 as far as
possible.
Z3 only:
Screw in spindle (1) on special tool 11 8 210 approx. 15 mm
and screw out again only after installation between special tool
11 8 200 and cooler.
RA Removing and installing or replacing vibration damper (M52TU / M54 / M56)
BMW AG - TIS
12.02.2013 23:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
