3 Series E46 320i (M52TU) SAL
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing (1). Detach
propeller shaft from transmission output flange and tie back to
side on vehicle underbody.
Version 1 without spring washer:
Grip output flange (1) with special tool 23 0 020 .
Release hexagon nut.
Tightening torque, 24 21 1AZ.
Remove output flange (1).
Installation:
Replace inner sealing ring on output flange (1).
Install hexagon nut with screw retaining compound.
Version 2 with spring washer:
Release hexagon nut (1) on output flange (2).
Tightening torque, 24 21 1AZ.
Installation:
Install hexagon nut with screw retaining compound.
RA Replacing radial seal for output flange (A5S 360R / 390R)
BMW AG - TIS
13.02.2013 02:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
