3 Series E46 320i (M52TU) SAL
Note:
If replacing complete seal: Procedure same as removing and
installing seal on front door/rear door, left or right,
refer to 51 71 000.
refer to 51 71 200.
Clean adhesive areas on door and seal with adhesive cleaner
(sourcing reference: BMW Parts Service).
Note:
Rubber separation serve as marking, do not remove
completely.
When coating seal with adhesive cleaner: observe a drying
time of approx. 5 minutes before continuing.
Adhesive areas must be dry and free of dust and grease.
Attach adhesive tape for positioning seal along rubber separations
on door.
Note:
Positioning of seal can no longer be determined properly:
If necessary, use positioning aids to install seal (sourcing
reference: BMW Parts Service).
Front door:
In area A ... B, apply a thin and even coat of profile rubber
adhesive (sourcing reference: BMW Service) to adhesive area on
front door and seal.
Width of adhesive area approx. 8 mm
Distance of adhesive area to:
-
Door seam approx. 1.5 mm
-
Edge of adhesive tape approx. 1.5 mm
-
If necessary, edges of positioning aids approx. 1.5 mm
Air drying time approx. 10 ... 15 minutes
RA Attaching seal on front and rear doors, left or right
BMW AG - TIS
13.02.2013 08:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -