3 Series E46 320i (M54) TOUR
Support transmission with workshop hoist.
Unfasten screws.
Tightening torque: 23 00 1AZ
.
Caution!
Do not allow the transmission to hang from the transmission
input shaft during removal and installation as this will deform
the clutch plate.
Pull out transmission towards rear as far as possible, rotate
approx. 10
°
counterclockwise and remove.
Subsequent work on transmission:
Support transmission with special tool 23 0 170 on assembly
stand 00 1 450 .
Installation:
Pay attention to adapter sleeves (1 and 2), replace if
necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
RA Removing and installing transmission (S5D 200G, S5D 250G, M52TU/M54)
BMW AG - TIS
13.02.2013 07:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
