3 Series E46 320td (M47TU) COMP
Tighten forcing screw (1) until H.P. pump is released from
sprocket wheel.
Remove H.P. pump.
Important!
Special tool 13 5 190 must remain in the vehicle to secure
the sprocket wheel and must not be removed under any
circumstances!
Remove jack screw (1) to install high-pressure pump.
Installation:
•
Replace gasket (1).
•
Note position of seal (1).
•
Sealing faces must be dry and grease-free.
Installation:
To vent fuel system:
Turn on ignition and leave on for approx. 1 minute. In this period
of time, the fuel pre-supply pump is activated and the fuel system
is filled with fuel and vented.
RA Removing and installing/replacing high-pressure pump (M47TU, M47T2)
BMW AG - TIS
13.02.2013 06:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
