3 Series E46 320td (M47TU) COMP
13 53 155
Removing and installing/replacing pressure
accumulator of injection system (M47TU)
Remove all pressure lines.
Caution!
When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an
alternator malfunction.
Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Detach plug (1) from pressure sensor (2).
Detach plug (7) from pressure regulator (8).
Release clamp (4).
Detach hose.
Release banjo bolt when replacing pressure accumulator.
Installation:
Replace gaskets.
Tightening torque of banjo bolt, 13 53 14AZ
.
Slacken injector-side union nuts on H.P. lines.
Release all union nuts on pressure accumulator.
Tightening torque of all union nuts, 13 53 8AZ
.
RA Removing and installing/replacing pressure accumulator of injection system (M47T
BMW AG - TIS
13.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -