3 Series E46 320td (M47TU) COMP
33 21 002
Removing and installing / replacing right
output shaft
Apply handbrake.
Remove rear wheel.
Unscrew collar nut (1).
Installation:
Replace collar nut, apply a light coating of oil to contact surface
and tighten down.
Tightening torque 33 41 1AZ
.
Secure collar nut (1) by peening at flat areas of output shaft.
Release rear stabilizer.
Release bolts and remove with washers (1).
Press output shaft off drive flange using a suitable tool; if
necessary, raise trailing arm with workshop jack approx. 20 mm.
Installation:
Before installing output shaft, make sure that drive flange is fully
engaged in rear differential.
Replace bolts and washers (1).
Tightening torque 33 21 1AZ
.
Press output shaft out of drive flange and remove towards center
of vehicle.
RA Removing and installing / replacing right output shaft
BMW AG - TIS
13.02.2013 09:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
