3 Series E46 320td (M47TU) COMP
34 52 525
Removing and installing/replacing front pulse
generator
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Open plug housing (1), pull plug connection (2) out of fixture and
disconnect.
Pull cable with rubber grommet out of fixture on spring strut and
on body.
Installation:
Ensure proper locking of plug connector and proper seating of
rubber grommets.
Release hexagon socket screw (1).
Withdraw wheel speed sensor (2) from bore hole.
Installation:
Tightening torque, 34 51 6AZ .
Installation:
Clean bore hole for pulse generator and grease with
Staburags NBU 12/K lubricating grease (refer to BMW
Service Operating Fluids).
RA Removing and installing/replacing front pulse generator
BMW AG - TIS
13.02.2013 10:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -