3 Series E46 323Ci (M52TU) COUPE
Installation:
Apply a thin and even sealing bead of Drei Bond 1209 (refer
to BMW Parts Service) at transition to half-moon sections at
VANOS adjustment unit.
Note:
Illustration with engine removed.
Installation:
Apply a thin and even sealing bead of Drei Bond 1209 (refer
to BMW Parts Service) at transition to half-moon sections at
rear of cylinder head.
Check seals and replace if necessary.
Note:
Illustration with engine removed.
Installation:
Make sure gasket is correctly seated on rear and front ends of
cylinder head.
Install cover bolts and align cylinder head cover.
Hand-tighten all cover bolts without preload. Tighten cap nuts
crosswise from inside to outside.
RA Removing and installing, sealing cylinder head cover (M52TU / M54 / M56)
BMW AG - TIS
13.02.2013 05:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -