3 Series E46 325Ci (M54) COUPE
12 14 521
Replacing pulse generator on crankshaft
(M54/M56)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
E46, E60, E61 only:
Remove reinforcement plate on front axle support.
Important!
The section Removing and installing reinforcement plate on
front axle support contains important installation instructions.
•
If fitted:
Remove vacuum reservoir for exhaust flap.
All models:
Note:
Installation location of pulse generator for crankshaft is
underneath starter motor.
Note:
For a better overview, this work step is shown on an engine that
has been removed.
Unlock plug (1) and remove.
Unscrew bolt (2).
Remove pulse generator (3).
RA Replacing pulse generator on crankshaft (M54/M56)
BMW AG - TIS
17.02.2013 14:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -