3 Series E46 325Ci (M54) COUPE
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Remove grease and abraded lining from taper splines of
clutch plate by mechanical means (with a cloth).
Then apply a thin and even coat of grease with a brush in
entire area of taper splines. Also in taper groove and on guide
pin.
Grease:
Refer to BMW Service Operating Fluids.
RA Removing and installing transmission GS5S31BZ (SMG)
BMW AG - TIS
17.02.2013 15:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
