3 Series E46 325Ci (M54) COUPE
52 13 015
Removing and installing / replacing controls
on left / right front seat (normal / manual)
Warning!
The actuating unit for front seats
which was fitted during car production
is different from the spare part.
Actuating unit version (A):
The two adjusting screws (1) and (2) for eccentric disks,
have a commercially available Torx screw head
which is sealed with hot-melt adhesive.
-
The adjusting screws (1) and (2) must not be adjusted in the
workshop.
-
The actuating unit may only be removed from
and refitted to the same front seat.
Actuating unit version (B):
The two adjusting screws (1) and (2) for eccentric disks,
are secured with tamper protection in the screw head.
-
The adjusting screws (1) and (2) must not be adjusted in the
workshop.
-
The actuating unit may only be removed from
and refitted to the same front seat.
Actuating unit version (C) (spare part):
The two adjusting screws for the eccentric disk have conventional
Phillips heads.
-
The adjusting screws (1) and (2) can be adjusted in the
workshop.
-
The actuating unit may be fitted to either front seat.
-
Prior to installation, apply an acid-free grease to thread; the
grease forces the eccentric disk upwards during adjustment
RA Removing and installing / replacing controls on left / right front seat (normal
BMW AG - TIS
18.02.2013 01:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -