3 Series E46 325i (M54) TOUR
21 54 505
Replacing clutch position sensor GS5S31BZ
(SMG)
Note:
After completing work:
Proceed according to test program.
refer to "Service Functions" in DIS Tester.
Remove heater bulkhead.
Remove complete exhaust system.
Release center bearing on propeller shaft. Release transmission
at cross-member and lower. The procedure and the tightening
torques are described in the section "Removing and installing
transmission".
Disconnect plug connection (4).
Release screws.
Tightening torque, 23 41 11AZ .
Remove clutch position sensor (2).
RA Replacing clutch position sensor GS5S31BZ (SMG)
BMW AG - TIS
14.02.2013 00:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -