3 Series E46 325i (M54) TOUR
Necessary preliminary tasks:
•
Remove propeller shaft from rear differential drive flange,
remove complete propeller shaft if necessary
Removing drive flange:
Lift out retaining plate.
Mark position of collar nut (1) on drive shaft with peening tool.
Brace drive flange with special tool 23 0 020 and release collar
nut.
Note:
Read and comply with document "Rear differential: Assignment to
model series".
210N, 215K, 220K:
Remove drive flange with special tools 31 2 101 , 31 2 102 ,
31 2 103 / 31 2 104 .
RA Replacing shaft seal for input flange on final drive
BMW AG - TIS
14.02.2013 04:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -