3 Series E46 325i (M56) TOUR
Secure crankshaft in firing TDC position with special tool
11 2 300 .
Important!
Do not turn the engine back.
Remove special tool 11 2 300 before switching on the
engine.
Fit special tool 11 3 240 to camshafts.
Note:
The timing is correctly set if the special tool 11 3 240 rests
without a gap on the cylinder head or protrudes up to 1 mm to the
inlet side.
The timing must be reset if the special tool 11 3 240 protrudes
to the exhaust side.
Remove special tool 11 6 150 .
Install VANOS adjustment unit.
Assemble engine.
RA Replacing camshaft (M52TU / M54 / M56)
BMW AG - TIS
14.02.2013 07:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 20 -