3 Series E46 325i (M56) TOUR
12 41 020
Removing and installing/replacing starter
motor (M54 / M56)
Follow instructions for disconnecting and connecting battery.
Disconnect and cover battery negative terminal.
Remove reinforcement plate on front axle support.
Caution!
The section "Removing and installing reinforcement plate on
front axle support" contains important installation instructions.
If fitted:
Remove vacuum reservoir for exhaust flap.
Unclip fuel line (1) from holders (2).
Note:
For a better overview, this work step is shown on an engine that
has been removed.
Unlock plug (1) of crankshaft pulse generator and disconnect.
RA Removing and installing/replacing starter motor (M54 / M56)
BMW AG - TIS
14.02.2013 09:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -