Replacing Battery Positive Lead for 3 Series E46 325i (M56) TOUR
Remove cover for fuel injectors.
Unclip battery positive lead (1) from holder (2).
Note:
Shown on E53.
Remove reinforcement plate on front axle support.
Caution!
The section "Removing and installing reinforcement plate on
front axle support" contains important installation instructions.
If fitted:
Remove vacuum reservoir for exhaust flap.
Unscrew nut (1).
Installation:
Tightening torque 12 41 4AZ.
Disconnect battery positive lead (2) from starter motor.
Remove battery positive lead.
-
Read out fault memory of DME control unit
-
Check stored faults
-
Rectify faults
-
Clear fault memory
RA Replacing battery positive lead (between starter motor and B+ terminal) (M54 / M
BMW AG - TIS
14.02.2013 09:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
