3 Series E46 325i (M56) TOUR
33 21 000
Removing and installing/replacing left or right
output shaft
Warning!
Scalding hazard!
Only perform the following tasks after the vehicle has cooled
down.
Apply handbrake.
Remove rear wheel.
Unscrew collar nut.
Installation:
Replace collar nut, apply a light coating of oil to contact surface
and tighten down.
Tightening torque 33 41 3AZ
.
Secure collar nut by peening on flat areas of output shaft.
Lower exhaust system at rear, remove if necessary.
Remove stabilizer from rear axle carrier and tilt downwards.
Release bolts and remove with washers (1).
Press output shaft off drive flange using a suitable tool; if
necessary, raise trailing arm with workshop jack approx. 20 mm.
Installation:
Before installing output shaft, make sure that drive flange is fully
engaged in rear differential.
Replace bolts and washers (1).
Tightening torque 33 21 1AZ
.
RA Removing and installing/replacing left or right output shaft
BMW AG - TIS
14.02.2013 12:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -