3 Series E46 325i (M56) TOUR
Pull out rubber mount with special tools 33 3 331 , 33 3 332 ,
33 3 333 and nut (1).
Draw in new rubber mount (1) with special tools 33 3 332 ,
33 3 333 and 33 3 334 to previously determined
protrusion (A).
After installation:
•
Check that output shaft is correctly seated in rear differential.
•
Perform chassis alignment check
RA Replacing one rubber mount/ball joint in trailing arm for lower control arm
BMW AG - TIS
14.02.2013 12:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -