3 Series E46 325i (M56) TOUR
34 11 000
Removing and installing/replacing brake
linings of both front disk brakes
Note:
After completing the tasks, press brake pedal several times to
the floor so that brake linings contact brake disks.
When installing new brake linings on the front axle and
simultaneously replacing the brake linings on the rear axle,
check the brake-fluid level and top up to the "MAX" marking if
necessary.
Remove wheels.
Refer to 36 10 300.
Lift out retaining spring (1).
Left:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
Remove plastic plugs (2).
Unfasten guide screws (1) and lift out brake caliper towards rear
of vehicle. Do not allow brake caliper to hang from brake hose,
risk of damage to brake hose.
Installation:
Only clean guide screws; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Tightening torque,
refer to Technical Data 34 11 3AZ .
RA Removing and installing/replacing brake linings of both front disk brakes
BMW AG - TIS
14.02.2013 13:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -