3 Series E46 328Ci (M52TU) COUPE
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disc (with a cloth).
Then apply a thin and even coat of grease with a brush in
entire area of taper splines. Also in taper groove and on guide
pin.
Grease,
refer to BMW Service Operating Fluids.
RA Removing and installing transmission (S5D 320Z M52TU/M54)
BMW AG - TIS
15.02.2013 00:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
