3 Series E46 328i (M52TU) TOUR
Installation (except E46 Compact and Z4):
Press center bearing (2) into transmission tunnel.
Lower transmission.
E46 only:
Lower until cylinder head touches end wall.
Suspend special tool 11 8 022 from left and right control arms.
Caution!
Position special tool so that engine oil sump rests securely on
special tool.
Tighten down knurled screws until special tool fits tightly with
engine oil sump.
Caution!
Relieve tension on clutch slave cylinder slowly when
removing; otherwise air will be drawn in through sealing
sleeve.
Release nuts and remove clutch slave cylinder. Pressure pipe
remains connected.
Tightening torque: 21 52 5AZ
.
Detach locking clamp.
RA Removing and installing transmission (S5D 200G, S5D 250G, M52TU/M54)
BMW AG - TIS
15.02.2013 00:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -