3 Series E46 328i (M52TU) TOUR
On vehicles with 15" rims, the front wheels must be removed if
necessary.
Important!
Make sure magnetic retainer (1) is correctly seated.
Place magnetic retainer (1) on control arm (2) below ball joint or
on moulded disk 31 1 071.
Important!
Measuring clip must not contact the control arm.
Fit measuring clip (1) on threaded stem (2) of ball joint and
screw down with locating screw (3).
Press button on evaluation electronics.
Note:
The device performs a self-test.
Both LEDs flash, then the red LED lights up permanently.
Move slide with measuring electronics upwards until green LED
lights up.
Note:
Gap (A) between measuring electronics and magnetic retainer
must be approx. 5-7 mm.
Then secure slide with clamping screw (1).
Press evaluation electronics button for approx. 2 seconds until
the green LED flashes.
Note:
The device is now calibrated and ready for measuring.
RA Measuring play of wheel control joints
BMW AG - TIS
15.02.2013 02:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -