3 Series E46 328i (M52TU) TOUR
Position of foam parts,
refer to 41 00 ... Layout of shaped parts for cavity bulkhead
Heat foam in following areas:
-
B-pillar
-
Side member cover, rear
Remove side member cover.
Drill out welding spots of remaining metal of extended
reinforcement, B-pillar, on car and remove remaining metal.
Straighten and grind joint surfaces.
Remove foam residue from cavity sealing.
On spare part, cover for side member, determine and mark out
cutting lines for "window" of B-pillar:
Measurement (E) = 350 mm from upper hinge fixture.
Measurement (F) = 430 mm from upper hinge fixture.
RA Replacing cover for side member, left or right (partial replacement, B-pillar be
BMW AG - TIS
15.02.2013 06:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -