3 Series E46 328i (M52TU) TOUR
Turn plug connection (1) in direction of arrow and unclip from
backrest frame (2).
Disconnect plug connection (1).
Note:
Secure drive for backrest angle adjustment (2) against falling out.
Release screws (1) and remove drive for backrest angle
adjustment (2) in direction of arrow.
If necessary, remove inner drive shaft from drive for backrest
angle adjustment (2).
Installation:
Ensure drive for backrest angle adjustment (2) is correctly seated
on inner flange.
Installation:
Ensure drive shaft (1) is correctly seated in drive for backrest
angle adjustment (2).
RA Removing and installing/replacing drive for backrest angle adjustment (front sea
BMW AG - TIS
15.02.2013 14:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -