3 Series E46 330Ci (M54) CONVER
Remove bearing pin (1).
Installation:
Grease bearing pin (1).
Grease,
refer to BMW Service Operating Fluids.
Detach cable plug (1) from reverse gear switch.
Detach cables from fixtures.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch disk.
Pull out transmission towards rear as far as possible, turn approx.
10
°
counterclockwise and remove.
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
RA Removing and installing transmission (S5D 320Z M52TU/M54)
BMW AG - TIS
15.02.2013 05:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
