3 Series E46 330d (M57) SAL
Installation:
Pull out constant-velocity joint (1) up to stop.
Fit shims.
Use new nuts.
Attach propeller shaft with constant-velocity joint pulled apart
to drive flange of final drive.
Alternately tighten 2 opposing nuts to draw constant-velocity joint
evenly into the input flange.
Tighten nuts.
Tightening torque 26 11 4AZ .
Installation:
Check centering mount (4).
Replace damaged centering mount.
Grease centering mount.
Grease,
Refer to BMW Service Operating Fluids.
RA Removing and installing complete propeller shaft (M57)
BMW AG - TIS
15.02.2013 07:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
