3 Series E46 330d (M57) TOUR
Supporting transmission:
Support with special tools 23 0 136 , 23 0 131 , 23 0 132
and 00 2 030 .
Unfasten screws and remove cross member.
Tightening torque 23 71 2AZ / 5AZ
.
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
When removing and installing the transmission, support the front
end of the engine at the housing with an installation aid
(e.g. transmission lifter).
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease,
refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
RA Removing and installing transmission (GS6-53BZ/DZ)
BMW AG - TIS
15.02.2013 12:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -