3 Series E46 330d (M57) TOUR
Adjusting camber:
Remove protective cap.
Twist/drive out centering pin (1).
Clean wheel arch from below in area of support bearing with
compressed air.
Slacken nut (2).
Slacken nuts (3) approx. 1 to 1.5 turns.
Insert special tool 32 3 140 in opening of wheel arch and over
nuts.
Turn nut in special tool 32 3 140 to adjust camber to specified
value.
Replace nut (2) and tighten down.
Tightening torque 31 31 1AZ
.
Remove special tool 32 3 140 .
Replace nuts (3) and tighten down.
Tightening torque 31 31 1AZ
.
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
15.02.2013 14:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -