3 Series E46 330d (M57) TOUR
Installation:
Remove centering pin (1) on spring strut support bearing or, for
"rough road package" suspension, on spacer ring (A) before
installation in a wheel arch without centering bore (e.g. strike off or
sever).
Caution!
Avoid damage to adjacent sheet metal parts.
Expose and cut connection points on engine support and firewall.
Expose and cut connection point, cover A-pillar/wheel arch.
Drill out welding spots on support carrier at top.
Determine and mark out partition area at connection, partial
replacement piece support carrier, top.
Measurement (A) = approx. 120 mm from center of bore (
∅
8 mm) for securing side wall.
RA Replacing front right wheel arch
BMW AG - TIS
15.02.2013 17:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -