bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 RA Replacing Battery Positive Lead (between Starter Motor And B- Terminal) (M54 _ M|Page 775 > < 2 RA Replacing Solenoid Switch
Page 1
background image

12 42 510

Replacing battery positive lead (between
starter motor and B+ terminal) (M54 / M56)

Read fault memory. Switch off ignition.

Observe safety instructions for handling vehicle battery.

Remove front underbody protection.

Follow instructions for disconnecting and connecting battery.

Disconnect battery negative lead from battery and lay to one side.

Open cable duct on lower section of microfilter housing and feed
out battery positive lead (1).

Fold up protective cap (1).

Unscrew nut (2).

Disconnect battery positive lead (3) from connection point.

Installation:

Tightening torque of screw (2), 12 51 4AZ.

RA  Replacing battery positive lead (between starter motor and B+ terminal) (M54 / M

BMW AG - TIS

15.02.2013  22:50

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

1 RA Replacing Battery Positive Lead (between Starter Motor And B- Terminal) (M54 _ M|Page 775 > < 2 RA Replacing Solenoid Switch